LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Body - Interior & Exterior - 2500 Hd) >> DECKLID/Hatch/Liftgate/Tailgate/Swing Gate >> Handle, Latch Release >> Installation

Handle, Latch Release: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0086820Courtesy of CHRYSLER GROUP, LLC
  1. Position the release handle (1) and the control (2) onto the tailgate.
  2. Install the two nuts (3) that secure the release handle and control to the tailgate. Tighten the nuts to 6 N.m (53 in. lbs.).
    GC0088939Courtesy of CHRYSLER GROUP, LLC
  3. Connect the backup camera electrical connector (1), if equipped.
    GC0086821Courtesy of CHRYSLER GROUP, LLC
  4. Locate the actuator rods (2) to the control using the reference marks made during the removal procedure and connect the rods to the control.
  5. Install the tailgate cover and liner, if equipped. Refer to COVER, TAILGATE, INSTALLATION .
scientia non olet · About LEMON Manuals