Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NO RESPONSE
1. Make sure the scan tool will communicate with the appropriate modules.
  Are you currently experiencing a NO RESPONSE condition?
  
  Yes
  - The NO RESPONSE condition must be properly diagnosed before continuing.
  - Perform the appropriate BUS Communication test. Refer to appropriate diagnostic information.
  No
  - Go To 2
DTC PRESENT
NOTE:
Before continuing, complete the 6.7L Cummins Turbo Diesel Diagnostic Worksheet. Go to the TechConnect > submit the vehicle's VIN number > Search Tab > and Select Create Diagnostic Worksheet.
1. Turn the ignition on.
2. With the scan tool, view PCM for DTCs.
  Is there a DTC present?
  
  Yes
  - Proceed to the MIL LIGHT ON PRETEST PROCEDURE. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
CHECK FOR SYMPTOM BASED ISSUES
1. Check the vehicle for one of the following conditions:
  - Engine No Start / Hard Start
  - Engine Misfires / Runs Rough / Poor Performance
  - Engine Noise
  - Excessive Smoke (Black/Blue/White)
  Do one of the following conditions exist?
  
  Yes
  - Perform the appropriate symptom based diagnostic procedure. Refer to DIAGNOSIS AND TESTING, 6.7L .
  No
  - Verify the vehicles performance by performing the Diesel Fuel System Validation procedure. Refer to STANDARD PROCEDURE .