Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool check active DTCs.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION - 6.7L diagnostic procedure. Refer to STANDARD PROCEDURE .
OTHER DTCS
Are the P24EA or U12A4 present?

Yes
- Perform the P24EA or U12A4 diagnostic procedure before proceeding.
- Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
No
- Go To 3
AMMONIA SENSOR
1. Replace the Ammonia Sensor.
2. Turn the ignition on.
3. With the scan tool, read DTCs.
  Is the DTC still active?
  
  Yes
  - Replace the Ammonia Sensor Module.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
  No
  - Repair complete.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .