Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
1. Ignition on, engine not running.
2. With a scan tool, select View DTCs.
  Is the U1417-IMPLAUSIBLE LEFT WHEEL DISTANCE SIGNAL RECEIVED Active at this time?
  
  Yes
  - Go To 2.
  No
  - Perform the INTERMITTENT CONDITION Diagnostic Procedure. Refer to INTERMITTENT CONDITION .
ABS MODULE IS ACTIVE ON THE CAN C BUS
1. Using the scan tool, select ECU View.
2. Verify that the ABS Module active on the bus.
  Is the ABS Module active on the bus?
  
  Yes
  - Go To 3.
  No
  - Perform the No Response from the ABS Module diagnostic procedure. Refer to NO RESPONSE FROM ABS (ANTILOCK BRAKE MODULE) .
DTCS STORED OR ACTIVE IN THE ABS MODULE
1. Check for DTCs in the ABS Module.
  Are any DTCs active or stored in the ABS Module?
  
  Yes
  - Go to and perform the appropriate diagnostic procedure.
  No
  - Go to 4.
ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)S IN THE TIPM
1. Using the scan tool, select ECU View and select TIPM.
2. Using the scan tool, read Active DTCs.
  Are any Communication DTCs active in the TIPM relating to the ABS System?
  
  Yes
  - Replace the ABS Module in accordance with the Service Information.
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
  No
  - Replace and program the Powertrain Control Module in accordance with the service information.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .