Removal And Installation

WARNING: This page is about a different car, the 2019 RAM 3500 HD and 2019 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

REMOVAL

Disconnect and isolate the negative battery cable(s). Refer to STANDARD PROCEDURE .
Remove the clean air hose. Refer to HOSE, CLEAN AIR, REMOVAL AND INSTALLATION, 6.7L .

Courtesy of CHRYSLER GROUP, LLC
Disconnect the Mass Air Flow (MAF) sensor wire harness connector (1).
Disconnect the Temperature/Barometric Absolute Pressure (T/BAP) sensor wire harness connector (2).
Detach the wire harness (3) from the clean air hose.

Courtesy of CHRYSLER GROUP, LLC
Remove the 14 push pins (1) and the radiator closure (2).

Courtesy of CHRYSLER GROUP, LLC
Remove the two bolts (1) securing the intake air tube (3).
Lift up on the air cleaner body (2) with intake air tube (3).

INSTALLATION

Courtesy of CHRYSLER GROUP, LLC

Install the air cleaner body (2) with intake air tube (3) and push down to lock in place.
Install the two bolts (2) securing the intake air tube (3) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC
Install the radiator closure (2) with the 14 push pins (1).

Courtesy of CHRYSLER GROUP, LLC
Attach the wire harness (3) to the clean air hose.
Connect the Temperature/Barometric Absolute Pressure (T/BAP) sensor wire harness connector (2).
Connect the Mass Air Flow (MAF) sensor wire harness connector (1).
Install the clean air hose. Refer to HOSE, CLEAN AIR, REMOVAL AND INSTALLATION, 6.7L .
Connect the negative battery cable(s). Refer to STANDARD PROCEDURE .