LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 1820 (Instrument Cluster (Service Information) - 2500HD & 3500HD) >> Switch, EVIC Control >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2019 RAM 3500 HD and 2019 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

REMOVAL 

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

  1. Disconnect and isolate the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECT .
  2. Remove the drivers air bag. Refer to AIR BAG, DRIVER, REMOVAL AND INSTALLATION .
  3. Remove the remote radio switches. Refer to SWITCH, REMOTE RADIO, REMOVAL AND INSTALLATION .
    GC0185875Courtesy of CHRYSLER GROUP, LLC
  4. Remove the four screws (1) from the EVIC switch bezel and remove the bezel from the steering wheel and disconnect the EVIC switch wire harness connectors.
    GC0185602Courtesy of CHRYSLER GROUP, LLC
  5. Remove the 6 screws (1) to the two EVIC switch retainers (2) and remove the EVIC retainers from EVIC bezel.
    GC0185268Courtesy of CHRYSLER GROUP, LLC
  6. Remove the EVIC switches (1) from the back of the EVIC switch bezel (2).

INSTALLATION 

GC0185268Courtesy of CHRYSLER GROUP, LLC
  1. Position the EVIC switches in to the EVIC bezel (2).
    GC0185602Courtesy of CHRYSLER GROUP, LLC
  2. Install the EVIC switch retainers (2) on to the EVIC switches (3).
  3. Install the six screws (1) for the EVIC retainers (2) to the bezel and tighten them securely.
    GC0185875Courtesy of CHRYSLER GROUP, LLC
  4. Position the EVIC switch bezel to the steering wheel and connect the wire harness connectors.
  5. Install the four screws (1) for the bezel to the steering wheel and tighten them securely.
  6. Install the remote radio switches. Refer to SWITCH, REMOTE RADIO, REMOVAL AND INSTALLATION .
  7. Install the drivers air bag. Refer to AIR BAG, DRIVER, REMOVAL AND INSTALLATION .
  8. Connect the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECT .
scientia non olet · About LEMON Manuals