LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Fuel System) >> Fuel Delivery - 2.2L Diesel >> Pump-Fuel Injection >> Removal

Pump-Fuel Injection: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: High-pressure fuel lines deliver fuel under extreme pressure from the injection pump to the injectors. This maybe as high as 1600 bar (23,200 psi). Use extreme caution when inspecting for high-pressure fuel leaks. Fuel under this amount of pressure can penetrate skin causing personal injury or death. Inspect high-pressure fuel leaks with a sheet of cardboard. Wear safety goggles and adequate protective clothing when servicing fuel system.
Fig 1: Battery Location
GC0041466Courtesy of DAIMLERCHRYSLER CORP.
1 - BATTERY
2 - PASSENGER SEAT
  1. Disconnect negative battery (1) cable located under passenger seat.
  2. Remove the engine cover. On 1.6L, (Refer to ENGINE - REMOVAL) or on 2.4L, (Refer to ENGINE - REMOVAL) .
    Fig 2: Air Cleaner Housing Assembly
    GC0041467Courtesy of DAIMLERCHRYSLER CORP.
    1 - TURBOCHARGER INLET HOSE
    2 - MAF SENSOR RETAINING BOLT
    3 - MAF SENSOR
    4 - O-RING
    5 - MAF SENSOR ELECTRICAL CONNECTOR
    6 - AIR CLEANER ASSEMBLY
    7 - INLET DUCT
    8 - AIR CLEANER HOUSING ASSEMBLY BRACKET
  3. Disconnect MAF sensor (3) electrical connector.
  4. Disconnect air inlet hose (7) and turbocharger inlet hose (1) from air cleaner housing (6).
  5. Remove air cleaner housing (6) assembly by pulling straight up out of mounts. On 1.6L, (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - REMOVAL) or on 2.4L, (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - REMOVAL) .
    Fig 3: INJECTION PUMP FUEL LINES
    GC0041465Courtesy of DAIMLERCHRYSLER CORP.
    1 - RETURN LINE FROM FUEL RAIL
    2 - INJECTION PUMP FEED LINE
    3 - INJECTION PUMP
    4 - HIGH PRESSURE LINE TO FUEL RAIL
  6. Remove fuel line retainer and retaining bolt from pump (3). Disconnect fuel supply (2) and return lines (1) at pump. See Fig 3.
  7. Disconnect high pressure fuel line (4) from pump to rail at injection pump. See Fig 3.
    Fig 4: INJECTION PUMP RETAINING BOLTS
    GC0041464Courtesy of DAIMLERCHRYSLER CORP.
    1 - INJECTION PUMP
    2 - INJECTION PUMP RETAINING BOLTS
    3 - HIGH PRESSURE LINE TO FUEL RAIL
  8. Remove injection pump retaining bolts (2) and remove pump (1) from cylinder head. See Fig 4.
scientia non olet · About LEMON Manuals