LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Exhaust System & Turbocharger) >> Charge Air Cooler And Hoses >> Installation >> Charge Air Cooler Hoses >> Hose - Charge Air Cooler To Throttle Body

Hose - Charge Air Cooler To Throttle Body

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position hose to mounting location.
  2. Connect hose to throttle body.
  3. Connect hose to charge air cooler.
  4. Tighten hose clamps to 1.7 N.m (15 in. lbs.).
  5. Connect Throttle Inlet Pressure (TIP) hose to charge air cooler hose.
  6. Connect Inlet Air Temperature (IAT) sensor connector.
  7. Install battery tray support bracket.
  8. Install battery tray and battery (Refer to ELECTRICAL/BATTERY SYSTEM/BATTERY - INSTALLATION) .
  9. Connect positive battery cable.
  10. Connect negative battery cable.
  11. Install air cleaner housing
scientia non olet · About LEMON Manuals