Bar - Stabilizer: Removal: RWD

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)
Remove belly pan. (Refer to BODY/EXTERIOR/BELLY PAN - REMOVAL)

Fig 1: Front Stabilizer Bar Heat Shield
Courtesy of DAIMLERCHRYSLER CORP.
On each side of vehicle, remove screws (1) fastening stabilizer bar heat shield (3). Remove heat shield.

Fig 2: Locating Front Stabilizer Bar Retaining Bolts
Courtesy of DAIMLERCHRYSLER CORP.
On each side of vehicle, remove bolts (2) fastening stabilizer bar isolator retainer (1) in place.

Fig 3: Locating Retainer Halves
Courtesy of DAIMLERCHRYSLER CORP.
On each side of vehicle, remove retainer halves (1)(2) from around stabilizer bar isolator (3).

Fig 4: Locating Front Stabilizer Bar and Bushing
Courtesy of DAIMLERCHRYSLER CORP.
Utilizing slit, remove each isolator (1) from stabilizer bar (2).

Fig 5: Link Ball Joint At Stabilizer Bar
Courtesy of DAIMLERCHRYSLER CORP.
On each side of vehicle, remove nut (5) fastening stabilizer link (3) to stabilizer bar (4). Slide link ball joint stem (1) from bar, then remove bar from vehicle.