Bar - Stabilizer: Removal: AWD

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)
Remove belly pan. (Refer to BODY/EXTERIOR/BELLY PAN - REMOVAL)

Fig 1: Link Ball Joint At Stabilizer Bar
Courtesy of DAIMLERCHRYSLER CORP.
On each side of vehicle, remove nut (5) fastening stabilizer link (3) to stabilizer bar (4). Slide link ball joint stem (1) from bar.

Fig 2: Stabilizer Bar Bushing and Retainer
Courtesy of DAIMLERCHRYSLER CORP.
On each side of vehicle, remove bolts (2) fastening stabilizer bar isolator retainer (3) in place.
Remove stabilizer bar with isolators and retainers from vehicle.
On each side of bar, remove retainers (3) from around stabilizer bar isolators (1).
Utilizing slit, remove each isolator (1) from stabilizer bar (2).