LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (HVAC Systems (Service Information)) >> Distribution >> Motor-Blower >> Installation

Section 78 (HVAC Systems (Service Information)): Distribution: Motor-Blower: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Blower Motor - With A/C, Typical
GC0020918Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the blower motor into the bottom of the HVAC housing.
  2. Install the three screws (2) that secure the blower motor (1) to the HVAC housing. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Reach through the glove box opening and engage the connector for the blower motor wire harness leads (3) to the retainer located on the HVAC housing.
  4. Connect the instrument panel wire harness connector to the blower motor wire harness connector and engage the connector lock.
  5. Install the glove box, (Refer to BODY/INSTRUMENT PANEL/BIN-GLOVE BOX - INSTALLATION) .
  6. Install the passenger side instrument panel silencer, (Refer to BODY/INSTRUMENT PANEL/SILENCER-INSTRUMENT PANEL - INSTALLATION) .
  7. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals