Bin-Glove Box: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: LHD model shown in illustration. RHD model similar.

Fig 1: Box-Glove

Courtesy of DAIMLERCHRYSLER CORP.

Install the glove box bin (4) onto the hinges located at the bottom of the instrument panel (3) by carefully rotating the bin into place.
Lift the glove box bin up partially up and install the damper (1) onto the driver side of the glove box bin.
Lift the glove box bin up into the instrument panel until the two retaining tabs (2) fully engage and close the glove box bin.
Reconnect the negative battery cable.