LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (1.6L SOHC Engine) >> Tube-Spark Plug >> Removal

Tube-Spark Plug: Removal

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Spark Plug Tube - Removal
GC0021486Courtesy of DAIMLERCHRYSLER CORP.
1 - SLIDE HAMMER C-3752
2 - SPECIAL TOOL 8819
3 - SET SCREWS
  1. Disconnect negative battery cable.
  2. Remove upper intake manifold (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - REMOVAL)  .
  3. Remove the cylinder head cover (Refer to ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S)  - REMOVAL).
  4. Remove lower intake manifold (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - REMOVAL)  .
  5. Position Special Tool 8819 on spark plug tube. Tighten the set screws to 16 N.m (142 in. lbs.). See Fig 1.
  6. Using Slide Hammer C-3752 (1) attached to 8819 (2), remove the tube from the cylinder head. See Fig 1.
  7. Loosen the set screws (3) and rotate Special Tool 8819 (2) one-quarter turn to remove from the tube. Discard the tube.
scientia non olet · About LEMON Manuals