Removal - Left Axle Seal
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Inboard (Left) axle seal replacement requires removal and disassembly of the axle assembly.
- Remove front axle assembly. (Refer to DIFFERENTIAL & DRIVELINE/FRONT AXLE - REMOVAL)
- Drain axle lubricant by turning housing on its side and draining out of left output bore.
- Remove differential cover (5) and differential (3). Remove and discard o-ring seal.
- Using Tool 9664 and Slide Hammer C-637, remove left axle seal.