LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Engine Cooling System & Automatic Transmission Cooling System) >> Transmission >> Cooler-Automatic Transmission Oil >> Installation >> Non - Turbo

Non - Turbo

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install transmission oil cooler and tighten screws to 8 N.m (70 in. lbs.).
    NOTE: When the transaxle cooler lines are removed from the rolled-groove type fittings at the cooler and transaxle, damage to the inner wall of hose will occur. To prevent potential leakage, the cooler hoses and clamps must be replaced.
  2. Replace automatic transmission cooler hoses and clamps.
  3. Connect hoses to cooler. (Refer to COOLING/TRANSMISSION - STANDARD PROCEDURE) .
  4. Install front fascia, (Refer to FRAME & BUMPERS/BUMPERS/FRONT FASCIA - INSTALLATION) .
  5. Start engine and check transmission fluid level. Adjust level as necessary.
scientia non olet · About LEMON Manuals