LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Frames & Bumpers) >> Front Bumper Fascia >> Installation

Front Bumper Fascia: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Fascia - Lower Grille Chrome A
GC0021973Courtesy of DAIMLERCHRYSLER CORP.
1 - FRONT FASCIA
2 - SPRING NUTS (6)
3 - PUSH PIN FASTENER
4 - LOWER RADIATOR GRILLE
5 - CHROME STRIPS
  1. Place fascia (1) on a work bench.
  2. Install lower radiator grille (4), and chrome strips (5), if equipped. Place chrome strip into position, and press on chrome strip until it is locked into position.
  3. Install lower radiator grille (4), if equipped. (Refer to BODY/EXTERIOR/GRILLE - LOWER RADIATOR - INSTALLATION) .
  4. Install air dam, retainer fasteners, foam and fog lamps if equipped.
  5. Place fascia in position and connect fog lamp wire connectors.
    Fig 2: Fascia Attaching Points
    GC0021972Courtesy of DAIMLERCHRYSLER CORP.
  6. Install two fasteners attaching fascia (2) to the fender bracket (1).
    Fig 3: Front Bumper Fascia
    GC0021971Courtesy of DAIMLERCHRYSLER CORP.
  7. Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .
  8. Install three screws attaching air dam (3) and lower fascia to the radiator support crossmember.
  9. Install spring nuts fasteners attaching fascia to fender flange.
  10. Install three screws attaching splash shield to fascia on each side of vehicle.
  11. Lower vehicle.
  12. Install radiator grille. (Refer to BODY/EXTERIOR/GRILLE - RADIATOR - INSTALLATION)
scientia non olet · About LEMON Manuals