LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (HVAC System (Service Information)) >> Plumbing >> Line-A/C Liquid >> Removal >> Front Section

Front Section

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing A/C Lines at Condenser
GC0013999Courtesy of DAIMLERCHRYSLER CORP.
  1. Recover the refrigerant from the refrigerant system (refer to REFRIGERANT SYSTEM RECOVERY ).
  2. Disconnect and isolate the negative battery cable.
  3. Remove the air cleaner housing (refer to appropriate ENGINE SERVICE INFORMATION article.
  4. Raise and support the vehicle.
  5. Remove the front end belly pan (Refer to REMOVAL ).
  6. Remove the nut (3) that secures the front section of the A/C liquid line (4) to the A/C condenser (5).
  7. Disconnect the A/C liquid line from the A/C condenser and remove and discard the dual plane seal.
  8. Install plugs in, or tape over the opened liquid line fitting and condenser outlet port.
    Fig 2: Remove/Install A/C Liquid Line - Front
    GC0014001Courtesy of DAIMLERCHRYSLER CORP.
    NOTE: LHD model shown. RHD model similar.
  9. Lower the vehicle.
  10. Remove the nut (1) that secures the front section of the A/C liquid line (2) to the rear section of the liquid line (3).
  11. Disconnect the front section of the A/C liquid line from the rear section of the liquid line and remove and discard the dual plane seal.
  12. Install plugs in, or tape over the opened liquid line fittings.
  13. Remove the front section of the A/C liquid line from the engine compartment.
scientia non olet · About LEMON Manuals