LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (HVAC System (Service Information)) >> Controls >> Actuator-Blend Door >> Removal >> Dual Zone Passenger Side

Dual Zone Passenger Side

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: LHD model shown in Fig 1. RHD model similar.
Fig 1: Removing/Installing Passenger Side Blend Door Actuator
GC0013924Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the glove box from the instrument panel (Refer to BODY/INSTRUMENT PANEL/GLOVE BOX - REMOVAL) .
  3. Remove the three screws (1) that secure the blend door actuator (2) to the passenger side of the HVAC air distribution housing (3).
  4. Remove the blend door actuator from the air distribution housing and disconnect the HVAC wire harness connector (4) and remove the actuator from the vehicle.
scientia non olet · About LEMON Manuals