LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Heated Seat System (Service Information)) >> Switch-Heated Seat >> Removal

Switch-Heated Seat: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Ash Receiver
GC0015941Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the ash receiver (1) from the instrument panel, (Refer to BODY/INSTRUMENT PANEL/ASH RECEIVER - REMOVAL) .
  3. Disconnect the heated seat switch connector (2) from the heated seat switch (3).
  4. From the back of the ash receiver (1), gently pry the switch (3) free and push the heated seat switch out through the front of the bezel.
scientia non olet · About LEMON Manuals