LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Body - Interior & Exterior) >> Instrument Panel >> Ash Receiver >> Removal

Ash Receiver: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Receiver-Ash Removal
GC0013461Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the gear shift center bezel from the floor console (4) (Refer to BODY/INTERIOR/CONSOLE-FLOOR - REMOVAL) .
  3. Set the emergency brake and place the gear shift lever into Low gear.
  4. Using a trim stick C-4755 or equivalent (1), remove the ash receiver (2) from the instrument panel (3) by releasing the snap retainers from the instrument panel.
    Fig 2: Locating Ash Receiver Wire Connections
    GC0013460Courtesy of DAIMLERCHRYSLER CORP.
  5. If equipped, disconnect the wire harness connectors (2) from the heated seat switches and remove the switches as required (Refer to ELECTRICAL/HEATED SEATS/SWITCH-HEATED SEAT - REMOVAL) .
  6. Disconnect the wire harness connector (3) from the lighter and remove the lighter assembly as required.
  7. Remove the ash receiver from the vehicle.
scientia non olet · About LEMON Manuals