LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Audio System (Service Information)) >> Antenna Cable >> Removal

Antenna Cable: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE) .
  1. Disconnect and isolate battery negative cable.
  2. Remove right side cowl trim panel.
  3. Disconnect antenna cable from instrument panel antenna cable.
  4. Remove right side front and rear door scuff plates (Refer to BODY/INTERIOR/DOOR SILL SCUFF PLATE - REMOVAL) .
  5. Remove right side C-pillar trim panel (Refer to BODY/INTERIOR/C-PILLAR TRIM - REMOVAL) .
  6. Disconnect antenna cable from antenna module.
  7. Move floor carpet aside.
  8. Remove antenna cable.
scientia non olet · About LEMON Manuals