LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Steering System (Service Information)) >> Pump >> Hose - Pressure >> Removal >> AWD

Hose - Pressure: Removal: AWD

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Disconnecting/Connecting Battery Cables
GC0012970Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate battery negative cable (2) from battery post.
  2. Siphon power steering fluid from pump reservoir.
  3. Remove air cleaner housing and inlet tube to throttle body. Refer to appropriate ENGINE - SERVICE INFORMATION article.
    Fig 2: Remove/Install Pressure Hose At Pump - 2.7L/3.5L
    GC0013303Courtesy of DAIMLERCHRYSLER CORP.
  4. 3.5L Engine - Unthread tube nut, then remove pressure hose (2) from pump (1).
    Fig 3: Remove/Install Pressure Hose at Pump - 5.7L/6.1L
    GC0013306Courtesy of DAIMLERCHRYSLER CORP.
  5. 5.7L/6.1L Engine - Unthread tube nut, then remove pressure hose (2) from pump (1).
  6. Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)
  7. Remove belly pan. (Refer to BODY/EXTERIOR/BELLY PAN - REMOVAL)
    Fig 4: Hose Mounting Bracket to Cradle
    GC0013312Courtesy of DAIMLERCHRYSLER CORP.
  8. Remove screw fastening pressure hose routing clamp (1) to front of engine cradle (2).
  9. Remove screw fastening pressure hose routing clamp to left side of engine cradle.
    Fig 5: Hoses at AWD Gear
    GC0013290Courtesy of DAIMLERCHRYSLER CORP.
  10. Unthread return hose tube nut (1), then remove return hose from steering gear (2).
  11. Unthread pressure hose tube nut (3), then remove pressure hose from steering gear (2) and vehicle.
scientia non olet · About LEMON Manuals