Fluid Cooler - SRT8/Police Package

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Battery Cables

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect and isolate battery negative cable (2) from battery post.
Siphon power steering fluid from pump reservoir.
Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)
Remove belly pan. (Refer to BODY/EXTERIOR/BELLY PAN - REMOVAL)

Fig 2: SRT8 FLUID COOLER AND HOSES
Courtesy of DAIMLERCHRYSLER CORP.
Remove hose clamp (1), then return hose (5) from steering gear at cooler (2).
Remove hose clamp (4), then return hose (3) to reservoir at cooler (2).

Fig 3: Cooler Retainer Clips
Courtesy of DAIMLERCHRYSLER CORP.
Push in on cooler mounting clip tabs.
Remove cooler from clips mounted to cooling module.