LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Restraints System (Service Information)) >> Passenger Airbag >> Removal >> NONDEPLOYED Passenger Airbag

NONDEPLOYED Passenger Airbag

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Right I/P Closeout Panel
GC0013493Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
    WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.
  2. Remove the right side silencer pad (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL SILENCER - REMOVAL) .
    Fig 2: Bin-Glove Box R and I
    GC0013482Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove the glove box assembly (Refer to BODY/INSTRUMENT PANEL/GLOVE BOX - REMOVAL) .
    Fig 3: Inboard Mounting Screws
    GC0016655Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove the two inboard mounting screws (2) to the passenger airbag just below the distribution duct (1) and to the left of the distribution housing.
    Fig 4: Outboard Mounting Screws
    GC0016654Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove the two outboard mounting screws (1) to the passenger airbag just below the distribution duct.
    Fig 5: Passenger Airbag Fasteners
    GC0016650Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove the two passenger airbag mounting bolts (2) to the crossbar beam.
  7. Disconnect the passenger airbag electrical connector (3).
    Fig 6: Passenger Airbag
    GC0016652Courtesy of DAIMLERCHRYSLER CORP.
  8. Maneuver the passenger airbag down in a way to clear any obstacles that may impede the removal of the airbag.
scientia non olet · About LEMON Manuals