LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 317 (5.7L Engine (Service Information)) >> Diagnosis And Testing >> Performance

Diagnosis And Testing: Performance

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
CONDITION  POSSIBLE CAUSE  CORRECTION 
ENGINE WILL NOT START 1. Weak battery. 1. Charge or replace as necessary.
2. Corroded or loose battery connections. 2. Clean and tighten battery connections. Apply a coat of light mineral grease to the terminals.
3. Faulty starter. 3. Refer to Electrical/Starting - Diagnosis and Testing
4. Incorrect spark plug gap. 4. Refer to Electrical/Ignition Control - Specifications
5. Dirt or water in fuel system. 5. Clean system and replace fuel filter.
6. Faulty fuel pump, relay or wiring. 6. See FUEL SYSTEM article.
ENGINE STALLS OR ROUGH IDLE 1. Idle speed set to low. 1. See appropriate Diagnostic information.
2. Vacuum leak. 2. Inspect intake manifold and vacuum hoses, repair or replace as necessary.
-
ENGINE LOSS OF POWER 1. Dirty or incorrectly gapped spark plugs. 1. Replace spark plugs.
2. Dirt or water in fuel system. 2. Clean system and replace fuel filter.
3. Blown cylinder head gasket. 3. Replace cylinder head gasket.
4. Low compression. 4. See CYLINDER COMPRESSION PRESSURE LEAKAGE .
5. Burned, warped or pitted valves. 5. Replace as necessary.
6. Plugged or restricted exhaust system. 6. Inspect and replace as necessary.