LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 311 (Vehicle Theft Security System (Service Information)) >> MODULE, Shaft Lock, Export >> Removal >> LHD - Module Unlocked

LHD - Module Unlocked

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Steering Column Cover Reinforcement
GC0082691Courtesy of CHRYSLER LLC
NOTE: Before attempting service, the ignition key must be inserted into the ignition lock cylinder. Once inserted, rotate the steering wheel from side to side. If the steering wheel can be rotated, the locking bolt is in the unlocked position. Leave the key in the ignition lock cylinder until shaft lock module removal has been completed. If the steering wheel cannot be rotated, test and repair the wiring circuits between the module and the ignition switch as required. If no problem is found in these circuits, the module has failed, see LHD - MODULE LOCKED . See Electrical/Vehicle Theft Security/MODULE, Shaft Lock - Removal .
  1. Remove the steering column opening cover. Refer to Body/Instrument Panel/COVER, Steering Column Opening - Removal .
  2. Remove the steering column cover reinforcement mounting screws (2). Remove the steering column cover reinforcement (1).
    Fig 2: Identifying Steering Column & Lock Retainer
    GC0137528Courtesy of CHRYSLER LLC
  3. Remove the steering column lock retainer (1).
  4. Remove and disconnect the steering column lock module from the steering column (2).
scientia non olet · About LEMON Manuals