LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Lighting Systems - Exterior (Service Information)) >> Switch-Headlamp >> Removal

Section 31 (Lighting Systems - Exterior (Service Information)): Switch-Headlamp: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable.
    WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.
    Fig 1: Headlamp Switch Electrical Connector
    GC0016116Courtesy of DAIMLERCHRYSLER CORP.
  2. Remove steering column opening cover (Refer to BODY/INSTRUMENT PANEL/STEERING COLUMN OPENING COVER - REMOVAL) .
  3. From underneath and behind the instrument panel, push up on the lower clip on headlamp switch then wiggle it down and out of instrument panel.
  4. Disconnect the headlamp switch electrical connector.
scientia non olet · About LEMON Manuals