LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Body - Interior & Exterior) >> Instrument Panel >> Cover-Steering Column Opening >> Removal

Cover-Steering Column Opening: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Column Cover, Wiring Connector & Park Brake Release Cable
GC0013217Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate negative battery cable.
  2. Remove the screws (2 and 6) that secure the steering column cover (1) to the instrument panel.
  3. Pull the steering column cover rearward at the top and right side of the cover to release the snap retainers from the instrument panel.
  4. Disconnect the wire harness connector (3) from the trunk release switch, if equipped.
  5. Disconnect the release cable (4) from the emergency bracket release handle (5) and remove the steering column cover from the vehicle.
    Fig 2: Reinforcement I/P Steering Column
    GC0013216Courtesy of DAIMLERCHRYSLER CORP.
  6. If required, remove the screws (3) that secure the instrument panel steering column cover reinforcement (1) to the bracket (2) and remove the reinforcement from the vehicle.
scientia non olet · About LEMON Manuals