5.7L/6.1L Engine
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - WATER PUMP ASSEMBLY |
| 2 - BOLT |
| 3 - DOUBLE ENDED BOLT |
- Install water pump and mounting bolts (2). Tighten mounting bolts to 28 N.m (20 ft. lbs.).
- Make sure double ended bolt (3) is in the proper location. Tighten double ended bolt to 28 N.m (20 ft. lbs.).
- Install thermostat (Refer to COOLING/ENGINE/ENGINE COOLANT THERMOSTAT - INSTALLATION) .
- Install accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLATION) .
- Install the radiator fan assembly (Refer to COOLING/ENGINE/RADIATOR FAN - INSTALLATION) .
- Connect negative battery cable.
- Fill cooling system (Refer to COOLING - STANDARD PROCEDURE) .
- Pressure test cooling system (Refer to COOLING - DIAGNOSIS AND TESTING) .