D-Pillar Trim: Removal
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the trim plate from the upper liftgate opening header (1). (Refer to BODY/INTERIOR/LIFTGATE OPENING UPPER TRIM - REMOVAL) .
- Loosen the rear edge of the quarter trim panel (4) from the inside of the lower D-pillar. (Refer to BODY/INTERIOR/QUARTER TRIM PANEL - REMOVAL) .
- Using a trim stick or another suitable wide flat-bladed tool, carefully pry the upper edge of the upper D-pillar trim (2) away from the headliner far enough to disengage the two upper spring clip retainers that secure the trim to the slots in the upper liftgate opening header and the inside of the D-pillar.
- Using a trim stick or another suitable wide flat-bladed tool, carefully pry the lower half of the upper D-pillar trim away from the D-pillar far enough to disengage the two lower spring clip retainers that secure the trim to the slots in the pillar.
- Disengage the lower edge of the upper D-pillar trim from under the quarter trim panel.
- Remove the upper D-pillar trim from the vehicle.