LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Body - Interior & Exterior) >> Interior >> C-Pillar Trim >> Removal >> Upper - Wagon

Upper - Wagon

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Upper C-Pillar Trim
GC0013503Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove the rear seat cushion from the vehicle. (Refer to BODY/SEATS/SEAT CUSHION COVER - REMOVAL) .
  2. Loosen the front edge of the quarter trim panel from the inside of the lower C-pillar. (Refer to BODY/INTERIOR/QUARTER TRIM PANEL - REMOVAL) .
  3. Remove the screw (3) that secures the lower end of the upper C-pillar trim (1) to the quarter inner panel (4).
  4. Using a trim stick or another suitable wide flat-bladed tool, carefully pry the rear edge of the upper C-pillar trim away from the quarter inner panel far enough to disengage the upper spring clip retainer that secures the trim to the slot in the quarter inner panel.
  5. Pull the lower edge of the upper C-pillar trim away and down to disengage the locator tab (2) on the back of the panel from the locator hole in the quarter inner panel.
  6. Remove the upper C-pillar trim from the vehicle.
scientia non olet · About LEMON Manuals