Lock Cylinder-Glove Box: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tumblers-Glove Box Lock R and I

Courtesy of DAIMLERCHRYSLER CORP.

NOTE: Be sure to install each tumble into their correct location within the lock cylinder.

If removed, install the springs (2) and the tumblers (1) into the glove box lock cylinder (3) in the order in which they were removed.

Fig 2: Lock-Glove Box Install 1
Courtesy of DAIMLERCHRYSLER CORP.
Install the ignition key (1) and the glove box lock cylinder (2) into the glove box latch (3) as an assembly.

Fig 3: Lock-Glove Box Install 2
Courtesy of DAIMLERCHRYSLER CORP.
Rotate the ignition key (1) counterclockwise until the lock cylinder (2) is fully retained in the glove box latch (3).
Install the glove box latch onto the glove box door (Refer to BODY/INSTRUMENT PANEL/LATCH-GLOVE BOX - INSTALLATION) .