Instrument Panel: Bezel-Cluster: Removal: Dodge

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Before proceeding with the following repair procedure, review all warnings and cautions.
Using a trim stick C-4755 or equivalent (1), gently pry between the ignition switch bezel (2) and the instrument cluster bezel (3) to release the snap retainers that secure the switch bezel.

Fig 1: Bezel-Ignition Switch Remove Dodge
Courtesy of DAIMLERCHRYSLER CORP.
Disconnect the wire harness connector from the headlamp switch (4) and remove the cluster bezel from the vehicle.

Fig 2: Bezel-Instrument Cluster Remove Dodge
Courtesy of DAIMLERCHRYSLER CORP.
Using a trim stick C-4755 or equivalent (1), gently pry between the cluster bezel (2) and the instrument panel (3) to release the snap clip retainers that secure the cluster bezel.
If required, remove the headlamp switch from the cluster bezel (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/HEADLAMP SWITCH - REMOVAL) .
Remove the ignition switch bezel from the vehicle.