LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Body - Interior & Exterior) >> Instrument Panel >> Bezel-Cluster >> Installation

Instrument Panel: Bezel-Cluster: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the cluster bezel (1) onto the instrument panel (2).
    Fig 1: Bezel-Cluster Install Chrysler
    GC0013476Courtesy of DAIMLERCHRYSLER CORP.
  2. Carefully push on the cluster bezel to fully seat the snap clip retainers into the instrument panel.
  3. Position the ignition switch bezel (1) into the cluster bezel (2).
    Fig 2: Bezel-Ignition Switch Install Chrysler
    GC0013477Courtesy of DAIMLERCHRYSLER CORP.
  4. Carefully push on the ignition switch bezel to engage the snap retainers that secure the switch bezel.
    5. Fig 3: Bezel-Cluster Install Dodge
    GC0013480Courtesy of DAIMLERCHRYSLER CORP.
  5. If removed, install the headlamp switch (1) into the cluster bezel (2) (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/HEADLAMP SWITCH - INSTALLATION) .
  6. Position the cluster bezel into the vehicle and connect the wire harness connector to the headlamp switch.
  7. Install the cluster bezel onto the instrument panel (3) and carefully push on the cluster bezel to fully seat the snap clip retainers into the instrument panel.
    Fig 4: Bezel-Ignition Switch Install Dodge
    GC0013481Courtesy of DAIMLERCHRYSLER CORP.
  8. Position the ignition switch bezel (1) into the cluster bezel (2).
  9. Carefully push on the ignition switch bezel to engage the snap retainers that secure the switch bezel.
scientia non olet · About LEMON Manuals