LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (3.5L Engine (Service Information)) >> Spring - Valve >> Installation >> Cylinder Head On

Cylinder Head On

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Valve Spring
GC0001871Courtesy of DAIMLERCHRYSLER CORP.
1 - MD 998772A
2 - SPARK PLUG TUBES
3 - CYLINDER HEAD
4 - 6527 - ADAPTER
5 - VALVE SPRING RETAINER
  1. Install new valve seal(s) if required. (Refer to ENGINE/CYLINDER HEAD/VALVE STEM SEALS - INSTALLATION) .
  2. Place valve spring (color-coded end facing up) and valve retainer into position.
  3. Compress valve spring using Special Tool MD 998772A (1) with Adapter # 6527 (4) only enough to install locks (5). See Fig 1.
  4. After installing locks, release tension on valve spring and verify proper installation.
  5. Remove Special Tool MD 998772A (1) and spark plug adapter tool.
  6. Install rocker arm and shaft assembly. (Refer to ENGINE/CYLINDER HEAD/ROCKER ARM/ADJUSTER ASSY - INSTALLATION) .
  7. Install cylinder head cover(s). Refer to appropriate cylinder head cover installation procedure.
  8. Install spark plugs.
  9. Install upper intake manifold. (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION) .
  10. Connect negative battery cable.
scientia non olet · About LEMON Manuals