LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (2.7L Engine (Service Information)) >> Valves & Seats-Intake/Exhaust >> Installation

Valves & Seats-Intake/Exhaust: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Checking Valve Spring Installed Height
GC0015306Courtesy of DAIMLERCHRYSLER CORP.
  1. Coat valve stems (2) with clean engine oil and insert them in cylinder head.
  2. If valves or seats have been reground, check valve tip height (5). If valve tip height (5) for intake valve is greater than 47.836 mm (1.883 in.) or 47.837 mm (1.883 in.) for exhaust valve, grind valve tip until within specifications. Make sure measurement is taken from cylinder head surface (7) to the top of valve stem (2).
  3. Install valve stem seals (8) (Refer to ENGINE/CYLINDER HEAD/VALVE STEM SEALS - INSTALLATION) .
  4. After installing valve stem seals, make sure the garter spring (9) is in place.
  5. Install valve spring (3) (Refer to ENGINE/CYLINDER HEAD/VALVE SPRINGS - INSTALLATION) .
scientia non olet · About LEMON Manuals