LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (2.7L Engine (Service Information)) >> Manifold-Exhaust >> Removal >> Left Exhaust Manifold

Left Exhaust Manifold

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Battery
GC0015222Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect negative battery (1) cable located in trunk.
    Fig 2: Air Cleaner Housing
    GC0015232Courtesy of DAIMLERCHRYSLER CORP.
  2. Disconnect intake air temperature sensor connector.
  3. Remove air cleaner housing assembly (3) (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - REMOVAL) .
  4. Remove oil dipstick tube (4).
    Fig 3: Left Exhaust Manifold
    GC0015376Courtesy of DAIMLERCHRYSLER CORP.
  5. Disconnect and remove oxygen sensor (2).
  6. Remove upper heat shield (1) and lower heat shield (4).
  7. Raise vehicle on hoist.
  8. Disconnect down stream oxygen sensor connector.
  9. Remove exhaust pipe from manifold (Refer to EXHAUST SYSTEM/CATALYTIC CONVERTER - REMOVAL) .
  10. Remove exhaust manifold attaching bolts and remove manifold.
scientia non olet · About LEMON Manuals