LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (2.7L Engine (Service Information)) >> Housing-Air Cleaner >> Removal

Housing-Air Cleaner: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Air Filter Assembly
GC0015271Courtesy of DAIMLERCHRYSLER CORP.
1 - THROTTLE BODY
2 - MASS AIRFLOW SENSOR ELECTRICAL CONNECTOR
3 - CLEAN AIR DUCT
4 - AIR FILTER HOUSING ASSEMBLY
5 - BOLT
6 - VENT TUBE
  1. Disconnect negative battery cable.
  2. Disconnect mass airflow sensor electrical connector.
  3. Remove clean air duct between throttle body and air filter housing.
  4. Remove vent tube.
  5. Remove mounting bolt.
  6. Remove air filter housing.
  7. Raise vehicle.
  8. Partially remove front fascia to gain access to air filter resonator (Refer to FRAME & BUMPERS/BUMPERS/FRONT FASCIA - REMOVAL) .
  9. Remove mounting bolt.
  10. Remove air cleaner resonator.
scientia non olet · About LEMON Manuals