LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (2.7L Engine (Service Information)) >> Lubrication >> Diagnosis And Testing >> Checking Engine Oil Pressure

Checking Engine Oil Pressure

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Oil Pressure Switch
GC0015225Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove the oil pressure switch (1) (Refer to ENGINE/LUBRICATION/OIL PRESSURE SENSOR/SWITCH - REMOVAL) .
  2. Install oil pressure test gauge assembly, Special Tools C-3292 with 8406 adaptor.
  3. Start engine and monitor gauge readings.
    CAUTION: If oil pressure is 0 at idle, Do not run engine at 3000 RPM.
  4. Oil Pressure (engine at operating temperature): Curb Idle  34.5 kPa (5 psi) minimum 3000 RPM  300-724 kPa (45-105 psi).
  5. If oil pressure is 0 at idle. shut off engine, check for pressure relief valve stuck open or a clogged oil pickup screen.
  6. Remove oil pressure test gauge assembly, Special Tools C-3292 with 8406 adaptor and install oil pressure switch after testing is completed (Refer to ENGINE/LUBRICATION/OIL PRESSURE SENSOR/SWITCH - INSTALLATION) .
scientia non olet · About LEMON Manuals