LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (2.7L Engine (Service Information)) >> Switch-Oil Pressure >> Removal

Switch-Oil Pressure: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Oil Pressure Switch
GC0015225Courtesy of DAIMLERCHRYSLER CORP.
  1. Raise vehicle on hoist.
  2. Remove lower splash shield.
  3. Disconnect oil pressure switch (1) electrical connector.
  4. Position an oil collecting container under switch location.
  5. Remove switch by unscrewing from the engine block.
scientia non olet · About LEMON Manuals