LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Wiper System & Washer System (Service Information)) >> Headlamp Washer Pump Motor >> Removal

Headlamp Washer Pump Motor: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Headlamp Washer Pump Motor
GC0016742Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose from the front (outboard) washer pump and allowing the washer fluid to drain into a container through a temporary jumper hose connected to the front washer pump.
  3. Remove the washer reservoir (Refer to ELECTRICAL/WIPERS/WASHERS/WASHER RESERVOIR - REMOVAL) .
  4. Disconnect the high pressure headlamp washer pump hose by pressing down firmly on latch and pulling hose off.
  5. Disconnect the high pressure headlamp washer pump motor electrical connector (1).
  6. Remove pump from reservoir by pulling pump up and away from reservoir cavity and out of mounting grommet. Do not damage reservoir/pump sealing surface or puncture reservoir during removal.
  7. Remove pump grommet and discard.
scientia non olet · About LEMON Manuals