Front Wiper Motor: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Wiper Module

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect and isolate the battery negative cable.
Remove the front wiper module (3) (Refer to ELECTRICAL/WIPERS/WASHERS/WIPER MODULE - REMOVAL) .

Fig 2: Removing Bellcrank Nut
Courtesy of DAIMLERCHRYSLER CORP.
With front wiper module on bench or in vise, remove the one nut attaching the bellcrank to the motor shaft.

Fig 3: Prying Bellcrank
Courtesy of DAIMLERCHRYSLER CORP.
Using a flat bladed tool, carefully pry the bellcrank from the wiper motor shaft.

Fig 4: Bellcrank
Courtesy of DAIMLERCHRYSLER CORP.
Separate the bellcrank from the wiper motor shaft.

Fig 5: Removing/Installing Motor Mounting Bolts
Courtesy of DAIMLERCHRYSLER CORP.
Remove the two motor mounting bolts (1).

Fig 6: Wiper Motor
Courtesy of DAIMLERCHRYSLER CORP.

NOTE: When separating the motor from the linkage, there are two pocket nuts that may fall out. Take care to keep these and reinstall them during installation.
Separate the wiper motor from the wiper module/linkage.