Section 122 (Cruise Control Systems): Servo: Removal: 1.6/2.0L

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Speed Control System Components

Courtesy of DAIMLERCHRYSLER CORP.

Remove the air cleaner lid and makeup air hose. Refer to appropriate article. Refer to (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER ELEMENT - REMOVAL) or (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER ELEMENT - REMOVAL) .

Fig 2: Removing/Installing Battery Negative Cable
Courtesy of DAIMLERCHRYSLER CORP.
Remove the negative battery cable.

Fig 3: Vacuum And Electrical Connection At Servo
Courtesy of DAIMLERCHRYSLER CORP.

1 - Electrical Connector

2 - Vacuum Line and Nipple
Remove two nuts attaching speed control cable and mounting bracket to servo. See Fig 1.
Remove servo from the mounting bracket.
Disconnect electrical connectors and vacuum hose.

Fig 4: Cable Retaining Clip
Courtesy of DAIMLERCHRYSLER CORP.

1 - HAIRPIN CLIP
Remove the engine cover.
Remove cable from throttle cam, (Refer to ELECTRICAL/SPEED CONTROL/CABLE - REMOVAL) .
Remove the 2 push nuts and discard.
Remove clip attaching cable to servo. See Fig 4.