LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (2.4L Engine - DTCS PO509 To P0850) >> Diagnosis And Testing >> P0632-Odometer Not Programmed In Pcm >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  PROGRAMMING MILEAGE INTO THE PCM 

    Ignition on, engine not running.

    With the scan tool, erase DTCs.

    Using a scan tool, program the mileage into the PCM.

    Start the engine.

    Allow the engine to reach normal operating temperature.

    With a scan tool, read DTCs.

    Does the DTC reset? 

    Yes 

    1. Replace and program the Powertrain Control Module per Service Information. Refer to MODULE-POWERTRAIN CONTROL and STANDARD PROCEDURE - PCM/ECM/SKREEM PROGRAMMING .
    2. Perform the POWERTRAIN VERIFICATION TEST. (Refer to STANDARD PROCEDURE - POWERTRAIN VERIFICATION TEST)

    No 

    1. The mileage has been successfully programmed into the PCM. Test is complete.
    2. Perform the POWERTRAIN VERIFICATION TEST. (Refer to STANDARD PROCEDURE - POWERTRAIN VERIFICATION TEST) .
scientia non olet · About LEMON Manuals