Power Length Adjuster

Fig 1: Power Length Adjuster

Courtesy of CHRYSLER LLC

Before proceeding with the following repair procedure, review all warnings and cautions. See WARNING .
Unbolt the seat from the floor as necessary to gain access to the riser bolts. See REMOVAL .
Move the seat to the forward position on the tracks, tip the seat backwards in vehicle and remove the seat adjuster bolts/nuts (1).
Move the seat to the reward position on the tracks and remove the front seat adjuster bolts/nuts (1).
NOTE: Manual seat length adjuster shown, power similar.
If the seat cannot be moved forward or backward, remove the seat cushion. See REMOVAL .
Remove the four bolts (1) and remove the motor and cable assembly (2) from the length adjuster assembly.
CAUTION: When the motor and cable assembly are removed from the tracks discard the length adjuster assembly and replace with a new one.

Fig 2: Passenger Seat Manual Track
Courtesy of CHRYSLER LLC
Disconnect and isolate battery negative cable.
Remove the seat off of the risers and disconnect the electrical connectors.
Disconnect strain gauge electrical connectors (1), if equipped.
If equipped, remove the strain gauge bolts (2) and remove the strain gauges as necessary.