Instrument Panel: Bezel-Center: Installation

Fig 1: Bezel-IP Center - Install

Courtesy of DAIMLERCHRYSLER CORP.

1. If removed, install the instrument panel air outlets onto the back of the center bezel (Refer to HEATING & AIR CONDITIONING/DISTRIBUTION/OUTLETS-AIR - INSTALLATION) .
2. If removed, install the power window switches onto the back of the center bezel (Refer to ELECTRICAL/POWER WINDOWS/SWITCH-POWER WINDOW - INSTALLATION) .
3. If removed, install the clock onto the back of the center bezel (Refer to ELECTRICAL/CLOCK - INSTALLATION) .
4. If removed, install the A/C-heater control and the accessory switch bezel onto the back of the center bezel. Install and tighten the retaining screws to 2 N.m (17 in. lbs.).
5. Position the center bezel (1) to the instrument panel (2) and connect the control cables and wire harness connectors to the back of the A/C-heater control (Refer to HEATING & AIR CONDITIONING/CONTROLS/CONTROL-A/C HEATER- INSTALLATION) .
6. Connect the wire harness connectors to the accessory switches, clock and power window switches (as equipped).
7. Install the center bezel onto the instrument panel. Make sure the snap retainers are fully engaged to the instrument panel.
8. Reconnect the negative battery cable.