LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Body & Frame >> Seats >> Heated Seat System (Service Information) >> Switch-Heated Seat >> Installation

Switch-Heated Seat: Installation

Fig 1: Identifying Accessory Switch Bezel Retaining Screws
GC0043526Courtesy of DAIMLERCHRYSLER CORP.
NOTE: There are different instrument panel switch pods available based on the option content of the vehicle. Ensure the switch pod being installed matches the vehicle options.
  1. Position the accessory switch bezel (2) onto the back of the instrument panel center bezel (3).
  2. Install the two screws (1) that secure the accessory switch bezel to center bezel. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Install the center bezel onto the instrument panel (Refer to BODY/INSTRUMENT PANEL/BEZEL-CENTER - INSTALLATION) .
  4. Reconnect the negative battery cable.
  5. Verify heated seat system operation.
scientia non olet · About LEMON Manuals