LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Vehicle Theft Security System - Electrical Diagnostics >> Vehicle Theft Security - Electrical Diagnostics >> DTC Troubleshooting >> B223C-Intrusion Transceiver Module Internal >> Diagnostic Test

Diagnostic Test

  1. 1)  DETERMINING IF DTC IS CURRENT 

    With a scan tool, read and record DTC(s).

    With the scan tool, clear DTC(s).

    Turn the ignition off and remove the key from the ignition.

    Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.

    Disarm the VTSS.

    Using the scan tool, read DTC(s).

    Does the DTC reset? 

    Yes 

    1. Replace the Intrusion Transceiver Module (Refer to REMOVAL) .
    2. Perform BODY VERIFICATION TEST - VER 1. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE - BODY VERIFICATION TEST - VER 1) , also see (STANDARD PROCEDURE - PCM/ECM/SKREEM PROGRAMMING) .

    No 

    1. DTC is not active at this time. Test complete.
    2. Perform BODY VERIFICATION TEST - VER 1. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE - BODY VERIFICATION TEST - VER 1) , also see (STANDARD PROCEDURE - PCM/ECM/SKREEM PROGRAMMING) .
scientia non olet · About LEMON Manuals