Removal & Installation
WARNING: This page is about a different variant/trim than selected.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Remove appropriate door opening weatherstrips. Using appropriate tool, pry seat belt shoulder height adjuster knob. Remove seat belt turning loop cover, anchor bolt and turning loop.
- Remove seat belt lower anchor bolt. Disengage upper B-pillar trim retaining clips and remove trim. Remove seat belt access panel from lower B-pillar trim panel. Remove appropriate door scuff plates. Disengage lower B-pillar trim retaining clips. Guide seat belt out through access hole and remove lower B-pillar trim. Disconnect side impact sensor electrical connector. Remove side impact sensor retaining screws and impact sensor.
- To install, reverse removal procedure. Tighten side impact sensor retaining screws and seat belt anchor bolts to specification. See TORQUE SPECIFICATIONS . DO NOT connect negative battery cable at this time. Perform air bag system check. See AIR BAG SYSTEM CHECK under SYSTEM OPERATION CHECK.