LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Sebring Limited, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Air Bag Restraint Systems - Except Coupe) >> System Operation Check >> Air Bag System Check

Air Bag System Check

WARNING: This page is about a different variant/trim than selected.
NOTE: Perform following check after component replacement.
  1. With battery disconnected, connect DRBIII scan tool to Data Link Connector (DLC). DLC is located under left side of instrument panel, near steering column. Turn ignition switch to ON position and exit vehicle with scan tool.
  2. Ensure no one is in vehicle, then connect negative battery cable. Using scan tool, read and record all active and stored DTCs. If any DTCs are present, go to DIAGNOSTICS . If no DTCs are present, perform DRBIII diagnostic trouble code erase function (active DTCs will not erase). Go to AIR BAG WARNING LIGHT CHECK .